Waterpik WP-480 Quick Start - Manual

QUICK START GUIDE
1
3 4
Model WP-480
The battery charger is only compatible with a voltage system of 120VAC, 60Hz.
Do not plug the battery charger into a voltage system that is different.
continued on back
The Water Flosser
has 3 settings on the
power switch.
O (off) ,
I (low) , and II (high) .
Use the low (I) setting
for first time use.
Increase to high (II)
pressure over time, if
you prefer – or as
instructed by your
dental professional.
Battery Pack Insertion:
Insert Tip: Adjusting Pressure:
Charge battery pack for
24 hours before first use
Slide battery pack
into handle, lining
up the arrows and
rotate clockwise
until it locks into
place. The arrow on
the battery pack will
line up with the lock
symbol on the back
of the Water Flosser.
Select the appropriate tip and insert
into the unit. Press firmly until the tip
clicks into place. Gently pull on tip to
confirm it is seated
properly and locked
in place.
Plug charger into standard
electrical outlet
(1) . Line up
arrow on the battery pack
with arrow on the charger
labeled “insert” and insert
battery pack
(2) . Rotate
battery pack until arrow
lines up with arrow labeled
“charge”
(3) . Green light on
the charger will illuminate.
For Showerpik ® installation instructions, please see instruction book
Caution: Do not press
tip eject button while
unit is running.
2
charge
Insert
charge
Insert
1
2
3
NO
Gap
Tip
Eject
Button
Insert