Waterpik SR-3000 Owners Manual - Manual (Page 6)

6
GETTING STARTED
Sonic brushing
• Slide the brush head onto handle and push it
down firmly.
• Place the brush head into your mouth before
turning the unit on.
• Press button once for low speed, and twice for
high speed.
• If you hold the on/off button down briefly while
in the low speed position the brush will shut off.
• For best results, position
brush along gumline at a
45-degree angle.
• Use light pressure with a
small, slow back and forth motion covering one
or two teeth at a time.
• Quad Timer: Your
Sensonic
® Professional
Plus Toothbrush will
create a short pause
every 30 seconds, to
remind you to move to
the next quadrant of
your mouth.
• 2-Minute Timer: The brush will automatically
shut off after 2 minutes of run time.
Unit will not operate if the
bottom LED begins to blink
rapidly.
In order for the toothbrush to
begin to work again, it must
be placed on the charger for
approximately 1 hour.
1 /
3
charge life
(recommend
recharge)
2 /
3
charged
Fully charged
Charging the Sensonic ®
Professional Plus Toothbrush
Charge for 24 hours before first use. All 3
charge indicator lights will stay on continuously
when the unit is fully charged. A full charge will last
for approximately 1 week of typical use (2 minutes
of brushing twice a day).
If the toothbrush is to be stored for an extended
period of time (six months or more), be sure to fully
charge it prior to storage.
Recharge Indicator Lights
Charge indicator lights will indicate level of battery
charge for approximately 10 seconds after use
and after removal from the charging base, and will
then turn off.
30
s
e
c.
30
s
e
c.
3
0
se
c.
3
0
s
ec
.