Wilson Manifolds 810100 Progressive Nitrous Controller and Vehicle Data Logger - Manual (Page 6)

Nitrous Pro-Flow, 4700 NE 11
th
St., Ft. Lauderdale, FL 33334 Pro-Flow Part. No. 810100
(954) 771-6216 www.nitrousproflow.com 1/2008
Page 6
Figure 5 – Analog Input Hookup to Daytona Sensors WEGO IIID Wide-Band System
WEGO IIID
TO SWITCHED
+12V POWER
RED
BLACK (2)
GROUND
SENSOR 1 AFR
OUTPUT
WHITE
BLUE SENSOR 2 AFR
OUTPUT)
SENSOR 1 INPUT
SENSOR 2 INPUT
BOSCH
LSU 4.2
SENSOR 1 CABLE
IDENTIFIED BY
YELLOW BAND
BOSCH
LSU 4.2
0-5V OUTPUT SCALED:
AFR = 10 + (2 x VOUT)
GROUND
STAGE 2
STAGE 1
PURGE SOL
GPIO
STATUS LED
PURGE IN
ARM
ANALOG 2
ANALOG 1
TPS
RPM
VSS
+12V POWER
USB PORT
POWER GROUND
POWER GROUND
OVERVIEW OF INITIAL SETUP
The nitrous controller requires initial setup to
establish nitrous system control parameters. PC Link
Nitrous software is used for setup. In addition, the
Nitrous Log data logging software is used to check for
proper scaling of the throttle position, RPM, and
vehicle speed inputs. Complete the software
installation and read the software sections of this
instruction manual, then continue the initial setup steps
on page 15.
PC REQUIREMENTS
The nitrous controller connects to your PC by
means of a USB interface. A USB cable is supplied
with the unit. The PC must have a free USB port. If you
have an older PC without USB capability, you cannot
use the controller.
We recommend a laptop PC with Pentium
processor and super VGA display (SVGA with 1024 x
768 pixel resolution) running Windows 98/ME/XPVista.
Data chart display is graphics intensive and a high
speed Pentium processor is recommended.
Processors slower than 300 MHz will exhibit sluggish
program loading and response. The PC must have a
CDROM drive for program loading.
PC Link Nitrous and Nitrous Log software
include print commands to print downloaded data. The
programs have been tested with Hewlett-Packard laser
and inkjet printers and Epson inkjet printers. We
recommend using a color inkjet printer.