WINGITS PREMIUM Peened Grab Bar WGB5PSPExx - Manual

Technical Data Sheet
Toll Free: 877-894-6448 • www.wingits.com • [email protected]
20140827_rev1
WGB5PE
Stainless Steel Grab Bar - Peened
PREMIUM
™
Width: See product part number for width. Complete length of Grab Bar is usable surface.
Diameter: 1.25” (3.2cm)
Entire product is stainless steel.
W ING I TS ®
PREMIUM ™ Structural Stainless Steel Grab Bars are designed to hold live loads and
must be installed into adequate structural blocking or with W ING I TS ®
Grab Bar Fasteners
Use: Wall Installation.
Load Capability: 800 lbs (362.9kg)
W ING I TS ® PREMIUM ™ Structural Stainless Steel Grab Bars meet or exceed the
applicable requirements of all building codes, ADA criteria, and 2010 ADAAG and
2009 ANSI standards.
For hollow wall construction, it is recommended that W ING I TS ®
Grab Bar Fasteners
are used with this product. See Fastener instructions for applications.
MECHANICAL DATA
PRODUCT COMPOSITION
MODALITY
INSTALLATION
CERTIFICATIONS
RECOMMENDED INTEGRATION
Model:
Part Numbers:
WGB5PSPE12
12’’ Polished Finish
WGB5PSPE16
16’’ Polished Finish
WGB5PSPE18
18’’ Polished Finish
WGB5PSPE24
24’’ Polished Finish
WGB5PSPE30
30’’ Polished Finish
WGB5PSPE32
32’’ Polished Finish
WGB5PSPE36
36’’ Polished Finish
WGB5PSPE42
42’’ Polished Finish
WGB5PSPE48
WGB5SSPE12
12” Satin Finish
WGB5SSPE16
16” Satin Finish
WGB5SSPE18
18” Satin Finish
WGB5SSPE24
24” Satin Finish
WGB5SSPE30
30” Satin Finish
WGB5SSPE32
32” Satin Finish
WGB5SSPE36
36” Satin Finish
WGB5SSPE42
42” Satin Finish
WGB5SSPE48
48” Satin Finish 48’’ Polished Finish
• All parts are Stainless Steel - tubing is 18-gauge (1.2mm)
• Mounting Flanges are 3”(75mm) in diameter, 3/32”(2.5mm) thick, HeliArc
welded to the tubing. Mounting Flanges have 5 holes for attachment to WINGITS
or adequate blocking.
• Snap-On Flange Covers are 22 gauge (0.8mm) drawn stainless steel, 3”(76mm)
in diameter and 3/8”(10mm) in height.
• Provide 1-1/2”(38mm) clearance from wall.
• Anti-Slip Grab Bar