Bosch LTC 5104 - Manual (Page 12)

LTC 5104, LTC 5108 Series | Instruction Manual | Installation EN | 12
Bosch Security Systems | 7 April 2004
4.15 Status Line
This menu determines what will be displayed on the
on-screen Status Line. There are three options: 1. A full
status line, which contains the camera number, camera
title, sequence mode, and alarm status information, 2.
Camera number and title only, or 3. Nothing at all (see
SCREEN 9).
SKIP/clr toggles the selection pointer of
the modes. The default is a full status line.
Screen 9
CAUTION: Selecting the status line option other than
the full status does not display the word ALARM on the
video.
4.16 Screen Display Brightness and
Background
The display brightness may be adjusted over seven
levels from black to white (see SCREEN 10). The
display background may be selected as silhouette
(profile), no silhouette (no profile), or block format.
Use
SKIP/clr to make the display lighter, and
ALARM darkens the display. When the end of the
brightness range has been reached, the background
format will toggle. The default background is
silhouette.
Screen 10
4.17 Screen Display Position
The display may be positioned both horizontally and
vertically (see SCREEN 11). The numeric
1 key is
used to move the display up, 2 to move down, 3 to
move left and 4 to move right. The default is bottom
center of the monitor screen.
Screen 11
4.18 Programming Camera Titles
With video present, access the Title Programming menu
by pressing and holding
RUN/next then pressing the
numeric 3 key (see SCREEN 12).
Screen 12
Once in the title setting screen:
• To call up and program the title for a particular
camera, enter the desired camera number via
the numeric keys. This displays the entered
camera # on all monitors (if video present).
• To move the cursor on the title screen, press
RUN/next.
• To increment characters, press ALARM.
• To decrement characters, press SKIP/clr.
• To exit, press DWELL.