Wolo 4100 The Deputy - Manual (Page 2)

INSTALLATION RECOMMENDATIONS
• For maximum sound be sure that the speaker connected to THE DEPUTY siren controller is not less then 100
watts. Recommended Wolo speakers are: Models 4002 or 4003
• The speaker should be mounted facing forward on the vehicle. To obtain maximum sound output, make sure that
the speaker is unobstructed. The siren’s sound can be severely reduced if objects are in front or blocking the
speaker.
• IMPORTANT: Installation of siren controller and wire routing must be out of the deployment path of vehicles air
bags.
• The siren controller must be installed in a location that will ensure safe operation of the controls and microphone.
• The siren’s controller must be mounted in a location that will provide good ventilation. Never install siren controller
close to a vehicle’s heater duct.
• Before drilling any surface for mounting of the siren controller or for routing wires, carefully inspect the desired
location to ensure that there are no components, wires and or any other vehicle part that could be damaged by
drilling.
• Before connecting the siren controller to the vehicle, carefully review the vehicle’s shop or build manual to ensure
the connection point will not affect the circuit or the vehicle’s operation.
• Speaker impedance: 6 to 8 ohms / 100 watt
IMPORTANT: Failure to follow all safety precautions and installation procedures outlined in these instructions could
result in property damage to the vehicle, serious injury or death to you or others.
MOUNTING SIREN CONTROLLER Fig. 1
1. IMPORTANT: Do not connect the siren
controller’s wires to any vehicle power point until
mounting of the controller is completed.
2. WARNING: If the vehicle is equipped with air
bags, the installer MUST consult the vehicle’s
shop or build manual to ensure that siren
controller and it’s wires will not affect deployment
of air bags. This siren must be installed only in a
location recommended by vehicle manufacturer. If
necessary consult manufacturer for their
recommendation.
2. Failure to adhere to this warning could result in
damage to the air bag and or reduce the
effectiveness of the air bag, which could result in
bodily injury, or death to you or others.
3. The swing bracket included has been designed to
mount to the siren controller either from the top for
hanging under dash or bottom for top surface
mounting.
CAUTION
• Before drilling any surface for mounting siren of the
siren controller or for routing wires carefully inspect
the desired location to ensure that there are no components, wires and or any other vehicle part that could be
damaged by drilling.
• The siren controller must be mounted in a location that will provide good ventilation. Never install siren controller
close to a vehicle’s heater duct.
4. Using the swing-mounting bracket as a template, mark the location of mounting holes to be drilled.
5. Drill two-(2) holes on the marked locations using a 15/64” drill bit.
6. Secure the swing-mounting bracket to the desired location using the hardware provided, (5.95 mm x 20-screws,
flat-washers, lock-washers and nuts).
7. The siren controller is secured to the mounting bracket using the hardware provided, (5.95 mm x 10-screws, lock-
washer and plastic washer). Tilt and position the siren controller so that it is easily reachable by user. Tighten the
two screws that secure the siren controller to the swing bracket.
Drill 15/64” hole