Wolo 7950-A Lookout Plus - Manual (Page 4)

19. Route the cable that has six-(6) colored wires to the switch controller. Match the cable’s colored wires to
the same colored wires coming from the switch controller. Connect the wires together using the insulated
bullet terminals’ that are factory installed onto the wires ends. Make sure the terminals rubber insulator fully
covers the metal terminal. See fig. 8.
WIRING POWER CABLE
See fig 8
Cable that has two wires (red and black)
20. WARNING: Failure to wire the light bar correctly could result in permanent damage to the light bar, the
vehicle’s electrical system and/or cause a fire. If any switch, fuse or wire is replaced, they must meet
or exceed specifications rating specified in this manual. Any deviation to the electrical specifications is
at the installers/users risk. IMPORTANT: Disconnect the vehicles battery before beginning any wiring.
IMPORTANT: The RED wire must be connected to the 10 amp inline fuse (included with light bar) at the
point of the 12-volt connection such as the fuse block, the vehicle’s battery or any 12-volt power source
which is rated by vehicle’s manufacturer capable of handling 10 amps. The fuse should never be more then
ten (10) inches from the power source. If either the red or black wires need to be lengthened use 18 gauge
or heaver wire.The light bar is a low current device, to operate this product at peak performance make sure
all connections are clean of paint, rust and corrosion and firmly secured.
21. RED & BLACK WIRES: Route the
wires to the vehicles fuse block,
accessory source or battery. If the
power wires pass through any drilled
holes or firewall, always use a rubber
grommet to protect the wire cables.
22. BLACK WIRE: Connect to ground by
securing wire under any metal body
bolt or the negative (-) battery post.
Make sure that the METAL surface
around the bolt that secures the wire
is clean of rust, oxidation and paint to
make a good electrical connection.
23. RED WIRE: Connect to positive (+) 12-volts such as the fuse block, accessory power source in the
dashboard area or the positive (+) battery post. Always use the provided 10-amp inline fuse. Make sure the
connection is at a location free from corrosion or oxidation.
24. BROWN WIRE: Connect to the wire that powers the vehicle’s brake lights, the wire that provides
(+) 12-volts when the brake pedal is depressed. Always install the 3-amp fuse provided as shown in fig. 8.
To prevent shorts make sure all wire connections are properly insulated.
25. Make sure all wires are securely fastened to vehicle using plastic wire ties or electrical tape (not provided).
WARNING: Carefully inspect the interior driver’s area to make sure the light bar wires or the vehicle’s
electrical system wires are not interfering with the operation of vehicle’s controls; accelerator, brake, clutch
pedals and etc.
26. Reconnect the vehicle’s battery. Installation is complete.
OPERATING LIGHT BAR
27. The switch controller has an on/off switch located at the top left corner, position the switch to ON. There is
a power indicator light that will illuminate on the front panel of the switch controller directly under the word
POWER.