Wood’s Powr-Grip STT1 - Manual (Page 13)

Rev 8.0/6-12 11 STT1: #35151
T
O
T
RANSPORT THE
L
OAD ON THE
T
ABLE
Apply the caster brakes and load the table in the folded position (see Figure B), as directed in T
O
L
OAD THE
T
ABLE
preceding. Secure the load onto the table using a strap or other appropriate
means.
WARNING: Make sure load will not cause table to tip over.
A folded table may lack sufficient counter-balance for the load and, if so, could tip over. Support
the load manually until you can verify that the table will not tip over while supporting or
transporting the load. If necessary, place appropriate weight on the table base to stabilize the
loaded table. Release the caster brakes and use 2 people to roll the loaded table to the desired
location; then reapply the caster brakes.
CAUTION: Make sure floor is clean and free from obstructions.
The table casters are designed to be used only on smooth, even surfaces, so make sure to keep
the floor where the table is used clean and free from obstructions.
T
O
U
NLOAD THE
T
ABLE
Before unloading a table, apply the caster brakes. If the table is in the horizontal position, make
sure that the tilt latch is fully engaged. Then remove the load carefully from the table, making
sure to use correct lifting technique.
A
FTER
U
SING THE
T
ABLE
Store the table in the folded position (see Figure B), in a dry location.