Wood’s Powr-Grip POSF1P9AC - Manual (Page 8)

Rev 11.0/12-13 6 POS-1P9AC: #35120
ASSEMBLY: WITH FLOOR-MOUNT BASE
Note: Components featured in the following instructions for assembling the product are
underlined on their first appearance in each step.
1) Open the shipping containers and carefully remove the product’s components, taking care to
avoid damaging the vacuum pad (see OPERATION illustrations).
Standard POSF1P9AC shown.
1 HEAD WITH EXTENSION TUBE 4 BASE FRONT TUBE 8 BASE REAR TUBE
2 SOCKET TUBE BOLT 5 HEAD ADJUSTMENT BOLT 9 BASE SOCKET TUBE
3 BASE BOLTS (3x) 6 POWER UNIT SCREWS (4x) 10 COTTERLESS HITCH PIN
7 POWER UNIT
2) Assemble the floor-mount base as follows: Identify the base front tube, base rear tube, base
socket tube and base bolts (with flat and lock washers). Slide the socket tube between the
two plates of the front tube so that the bolt holes align. Insert a base bolt with lock washer
through each set of holes as illustrated. Place a flat washer on the portion of each bolt
extending beyond the rear plate of the front tube. Place the rear tube near the front tube as
illustrated, in order to thread the bolts into the threaded holes of the rear tube. Tighten all
bolts securely.
3) Install the tilt/rotation head with extension tube in the floor-mount base as follows: Identify
the socket tube bolt (with 2 flat washers, 1 lock washer and 1 nut) and the cotterless hitch
pin; if these parts are installed in the base socket tube, remove them. Slide the extension
tube into the socket tube as illustrated. Set the head height by sliding the extension tube up
or down until the side holes align in both tubes at the height desired for using the product;
then push the cotterless hitch pin through the holes until the retaining ball emerges on the far
side of the socket tube. Secure the extension tube by inserting the socket tube bolt with a
flat washer through the front/rear holes of both tubes as illustrated; then place a flat washer,
lock washer and nut on the threaded portion extending beyond the socket tube, and tighten
the bolt securely.