WORX WU706 115mm 710W Angle Grinder 240V - Manual (Page 14)

14
ROUgH gRINDINg
The best roughing results are achieved when setting the machine
at an angle of 30° to 40°. Move the machine back and forth with
moderate pressure. In this manner, the workpiece will not become
too hot, does not discolour and no grooves are formed.
Warning! Never use a cutting disc for roughing.
CUTTINg
Warning! For cutting metal, always work with the wheel
guard for cutting.
When cutting, do not press, tilt or oscillate the machine. Work with
moderate feed, adapted to the material being cut.
Do not reduce the speed of running down cutting discs by applying
sideward pressure.
The direction in which the cutting is performed is important.
The machine must always work in an up-grinding motion. Therefore,
never move the machine in the other direction! Otherwise, the
danger exists of it being pushed uncontrolled out of the cut.
ROTATINg THE gEAR CASE
Before any work on the machine itself, pull the mains plug, and
then remove the disc and guard
The gear case can be rotated with respect to the machine housing. In
this manner, the On/Off switch can be brought to an advantageous
handling position for special working situations.
Remove the 4 x screws from the gear case. Carefully rotate the gear
case in your desired direction but do NOT pull the gear case out of
the housing. If the gear case comes out of the housing the motor
carbon brushes will need replacing.
Screw in the screws again and tighten. (See Fig. F)
2
3
E
F