WORX WU127 12V 1.3 Ah Lithium Ion Cordless Drill/ Driver - Manual (Page 9)

9
1
Operating instructions
Note: Before using the tool, read the instruction book carefully.
iNteNDeD USe
The machine is intended for driving in and loosening screws as well
as for drilling in wood, metal and plastic.
BefoRe PUttiNG iNto oPeRatioN
• CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion battery
installed in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to
cool down before recharging.
When the battery pack is charged for the first time and after
prolonged storage, the battery pack will accept a 100% charge
after several charge and discharge cycles.
• TO REMOVE OR INSTALL BATTERY PACK (See A)
Depress the battery pack release button to release and slide the
battery pack out from your tool. After recharge, slide it back into
your tool. A simple push and slight pressure will be sufficient.
oPeRatioN
oN / off SwitcH (See B)
Depress the On/Off switch to start and release it to stop your drill.
A B
C D
E F