WORX WU651 300W vibrafree Rotary Sander 125mm 240V - Manual (Page 12)

12
Make sure the sanding paper is even with the edges and that the
sanding paper is taut on the pad.
Remove the abrasive paper by pinching an edge and peeling off
(See Fig B)
CYCLONIC DUST BOX (See Fig C)
A) ATTACH THE CYCLONIC DUST BOX
Your sander is equipped with a cyclonic dust box. To attach, slide
the box onto the outlet piece and take care that the latching lever
engages.
Caution: To prevent the possibility of sanding dust or foreign
body being thrown into your face or eyes, never attempt to use
your sander without the box properly installed.
B) EMPTY THE CYCLONIC DUST BOX (See Fig D1, D2)
For more efficient operation, empty the cyclonic dust box every
5-10mins. This will permit the air to flow through the box better.
To empty the box, press the latching lever in and pull off the box.
Then press the button at the rear of the box to open it, and shake
out dust.
USING THE DUST EXTRACTION ADAPTER (See Fig.E)
Your sander is equipped with a dust adapter, which is designed for
collect dust task. To attach, slide the adapter onto the outlet piece
and take care that the latching lever engages. Then connect the
2
3
D.2
D.1
10
E
C