WORX WU334L 900W SDS Rotary Hammer Drill 110V - Manual (Page 8)

8
1
Operating instructions
note: Before using the tool, read the instruction book carefully.
intended uSe
The machine is intended for hammer drilling in concrete, brick and
stone as well as for light chiseling work. It is also suitable for drilling
without impact in wood, metal, ceramic and plastic.
Warning! Before any work on the machine itself, pull the
mains plug.
inSeRting and ReMoving dRill BitS in tHe Quick
cHange SdS-PluS cHuck
take care that the dust protection cap is not damaged when
changing tools.
1) inSeRting (See fig. a1)
Clean and lightly grease the bit with the oil provided before inserting.
Insert the dust-free bit into the bit holder with a twisting motion until
it latches.
The bit locks itself. Check the locking by pulling on the tool.
2) ReMoving (See fig. a2)
Retract back the bit holder locking sleeve (a) and pull out the bit.
Warning!your new WoRX Rotary Hammer drill generates
powerful forces to get your job done quickly and effectively. these
forces may cause inferior quality SdS bits to break and jam in the
chuck.We therefore recommend that only high quality SdS bits
be used with this tool.
A1
A2
I
a
II