X-1 (H2O Audio) S6-1A3 - Manual (Page 5)

This T-seal is correctly seated in a closed
housing, sealing the housing and
protecting the iPod from water.
Correct
The misaligned T-Seal becomes pinched
between the base and lid (as Shown)
creating an opening in the housing that
will cause the housing to flood.
Incorrect
It is extremely important that you
keep the T-Seal clean & free of
sand, dirt, hair, lint, and other
debris.
To clean the T-Seal remove it from
the housing.
Wash T-Seal in warm fresh water,
ensuring all debris is cleaned from
the T-Seal.
*Strong detergents, soaps, and
chemicals MUST NEVER be used to
clean the Housing or the T-Seal.*
Allow T-Seal to air dry. Once dry
install back into the housing.
Please refer to the “How to install
/ replace your T-Seal” on how to
properly install the T-Seal.
For long term storage, store in a
plastic bag out of direct sunlight.
5. Gently close lid and lock latch. The lid
should close without any resistance. If
you experience any resistance when
closing the housing please call customer
service immediately at 1.800.708.6080
x213 before using your housing.
6. Visually inspect the outside of the
housing and ensure the T-seal is installed
correctly. If the T-Seal is dirty, out of
alignment, twisted or pinched in any way
it will compromise the integrity of the
housing and should not be used.
Cleaning & Storing the T-Seal How to install / replace the T-Seal