Zero Gravity Honda VFR 800 (2002 and up) Windscreen - Manual

Honda VFR 800 2002 - 2010 DIY Windscreen Install
1
454 install
Rev. A
Fig 3. HERE IS THE TRICKY PART! Locate the fair-
ing slots and windscreen U hooks before applying
any inserting pressure. There will be four u-hooks,
two on each side.
(See FIG3A).
FIG1
Fig 2. After removing the stock windscreen, insert the
Zero Gravity windscreen from the back of the fairing in
a reclined position as shown in
Fig 2.
Helpful hints: Use metric tools, clean hands, put the bike on a stand. Do not pry on the screen excessively, as it can break
without much warning.
Installation Instructions for Honda VFR 800 2002 and up.
Thank you for purchasing Zero Gravity’s windscreen, which has been designed and manufactured to give years of safe &
fun riding. These instructions give you an in-depth look at the
installation process. To receive further assistance or parts please
e-mail [email protected].
PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN
FIG2
FIG3
Fig 3A. Insert the U-hooks into their respective slots
by applying a light pressure as shown. This photo
shows pressure locations on either side of the screen.
Be careful not to exert to much force!
FIG3A
Fig 1. Remove both mirrors. Locate both fasteners
located on the outside and inside fairing. Be careful not
to drop the mirrors!
U-Hooks
Fairing
Slots
Positioned
in front of
the fairing
Location
For Light
Pressure
Reclined
back,
positioned
behind the
fairing.
WWW.ZEROGRAVITY-RACING.COM
The factory Honda wind-
screen incorporates two
tabs that fasten the screen
to the fairing cowl. These
tabs have been eliminated
on your ZG screen. This
was done deliberately by
the ZG designers to aid in
our ability to manufacture
this screen and for ease of
installation. Please Note: