Boss Audio Systems PLL SYNTHESIZER STEREO RADIO BV7280 - Manual (Page 19)

17
OPERATION
the audio/video/photo files in the card and
start to play automatically. The operation is
the same with the USB operation described
above.
If in other mode, you can also press MODE
button to select Card mode.
The corresponding operation please refer
to the USB PLAY OPERATION.
RADIO OPERATION
◆ Switching to Radio Mode
Press MODE button on remote control or
MODE
on the front panel start radio mode.
The band/frequency/station/clock and
other information will display on the
display.
◆ Selecting the Frequency Band
Press BND button on the remote control
or BAND/AMS button on the front
panel to select desired band. The
reception band will change in the following
order:
Æ FM1Æ FM 2Æ FM3 Æ AM1 Æ AM2
◆
Selecting Station
Press / buttons on the remote
control or press / on the front panel
shortly to adjust the frequency manually.
Hold Press / on the remote control
or hold press / on the front panel for
fast tuning. The frequency is updated
correspondingly on display.
◆ Setting Memory
Press radio preset buttons (numeric
buttons 1~6) on remote control or on the
front panel to preset stations at radio
mode. Each band can store six preset
stations. The stations might be FM1, FM2,
FM3, AM1 and AM2 band. The operation
is as below:
1) Store in Memory
Press and hold desired radio preset
buttons (numeric buttons 1~6) on the
remote control or on the front p anel for
several seconds, the memory icon will
be shown display and the current
listening station will be stored into the
number button.
2) Retrieve a Preset Station
Press any one of the radio preset
buttons (numeric but tons 1~6) on the
remote control or on the front p anel to
retrieve a station which had been stored
in the memory in advance and the
chosen frequency will be shown on
display.
◆ Automatic memory storing &
program scanning
1) Program scanning
Shortly press AMS button on remote
control to scan preset station.
2) Automatic memory storing
Press and hold press AMS button on
the remote control or BND/AMS
button on the front p anel for about
several seconds, the radio searches
from the current frequency and checks
the signal strength until one cycle
search is finished. And then st ations
are stored into the preset number
button in turn according to the strength
of the st ations. When auto search is
finished, it will e nter into preset scan
mode automatically.
Note:
Press and hold 1-6 numeric
buttons on the remote control for about
several seconds, will store the current
station to the current numeric key
position.
◆ Mono/Stereo
Press ST button on remote control to
select mono or stereo mode. Y ou can
sometimes improve reception of distant
stations by selecting mono operation.
RADIO ST
87.50 MHZ
BAND : FM1
STATION: M1
POP 00:03