3D Robotics Telemetry Radio - Manual (Page 3)

TIPS
Orient the ground radio
antenna vertically for
maximum range.
CONNECT TO TABLET
Connect the ground module to your tablet using the Android adapter cable. Connect the colored end
to the tablet and the black end to the radio. In
DroidPlanner or Andropilot , select Connect .
DroidPlanner Flight Data screen
View the strength of the radio signal in the
mission planner’s flight data screen.
SETTINGS
To change the radio settings in the mission planner, connect the radio to your computer, but do not
select Connect. Radios can only be configured while unconnected to MAVLink. Select
Initial Setup ,
3DR Radio , and Load Settings to configure the radios.
All settings should be the same for both modules. Ensure that the Net ID setting is identical on each
radio to enable pairing. Select Save Settings to apply settings. For flying with friends, make sure your
Net IDs do not conflict.
Use the configuration options on this screen to apply the correct airspace regulation requirements
for your area. You are responsible for complying with all airspace regulations in your area, including
frequency restrictions, power levels, and licenses. For more information on configuring 3DR Radios to
comply with local regulations, visit the online documentation at
goo.gl/Tsrksf .