Removing support material – Afinia H480 3D Users Manual User Manual
Page 32
Afinia H480 3D Printer User’s Manual
32
Removing Support Material
Printed models are composed of two parts. One part is the model itself, and the other part is the
support material used to support any overhanging parts of the model.
The support material is the same physical material as the model material, but printed at a much
lower density. Support material is very easy to distinguish from the model material, making it is
easier to remove.
The left picture above shows the teapot with its support material still attached, while the right
picture shows the teapot with support material removed.
The support material can be removed using a combination of tools. Some material can easily be
removed by hand. Support material close to the model is easier to remove using tools such as
wood carving chisels, long nose pliers, or wire cutters.
GLOVES/SAFETY GLASSES: The support material and the tools are sharp.
Wear gloves and safety glasses when removing the part from the printer.
ALWAYS WEAR GLOVES AND SAFETY
GLASSES WHEN REMOVING THE SUPPORT
MATERIAL!