Rockwell Automation 1336S_F_T_E_R F Frame Snubber Resistor Repl. - Manual (Page 5)

Bulletin 1336 Service 5
Black Wire = "Resistor Bottom Right" (P/N 306237-Q04)
Apply a thin layer of thermal grease from the supplied blister pack
to the back side of the resistor mounting bracket to aid in heat
conduction when the resistor is dissipating heat into the drive sheet
metal.
5. Attach this resistor to the bottom of the half bridge assembly (red
wire on left) using the two remaining new screws supplied in the kit.
6. Attach the wires as indicated at their terminated ends:
Black wire = J2 (-) INV using pliers
Red Wire = POS CAP BUS using the Phillips screwdiver and one
of the screws you previously saved.
Refer to Figure 5.
7. Tie any loose resistor wire using the tie wraps supplied in the kit.
Cut off any excess with side cutters.
8. Reinstall the plastic protection cover before re-applying power to
the drive.