Rockwell Automation 7000 DPI Wireless Interface Module - Manual (Page 17)

Chapter
2
Installing the WIM
Chapter 2 provides instructions for installing and removing the WIM.
The WIM is offered in two styles: a NEMA 1 module (20-WIM-N1) and
a NEMA 4 module (20-WIM-N4S). Each style is installed differently.
The NEMA 1 WIM (20-WIM-N1) typically replaces the HIM, and is
normally installed in the HIM (Human Interface Module) cradle on the
front of the drive. When a HIM is still required and occupies the cradle,
the 20-WIM-N1 module can be installed in a HIM bezel (20-HIM-B1)
mounted in a remote location.
Installing the WIM in a Drive
1. If a HIM is installed on the drive, remove the HIM, and replace it
with the WIM ( Figure 2.1 ).
Important: If the drive is mounted in an enclosure, the NEMA 1
WIM must be installed in a HIM bezel or you must use
a NEMA 4 WIM. Using the NEMA 1 WIM installed at
the drive (DPI Port 1) in the enclosure will decrease
wireless signal transfer, resulting in possible
intermittent disconnection of the drive.
2. The status LED on the WIM momentarily flashes red on powerup
and then flashes green to indicate it is ready to establish wireless
communication with the Pocket PC or computer.
3. Establish wireless communication between the WIM and the Pocket
PC or computer. For this procedure, refer to the respective section in
Chapter 3 that corresponds to the drive software tool you are using:
Topic Page
Installing the NEMA 1 WIM (20-WIM-N1) 2-1
Installing the NEMA 4 WIM (20-WIM-N4S) 2-3
Removing the NEMA 1 WIM (20-WIM-N1) 2-5
Installing the NEMA 1 WIM (20-WIM-N1)