Rockwell Automation 7000 DPI Wireless Interface Module - Manual (Page 24)

3-2 Configuring the WIM
With Pocket DriveExplorer for Pocket PC software running on a Pocket
PC equipped with Bluetooth wireless technology, you can edit parameters
in the WIM, connected drive, and any of the attached peripherals.
If you are unsure how to use Pocket DriveExplorer for Pocket PC, refer
to the online help (select Help > Help Topics).
Establishing Wireless Communication Between the WIM and
Pocket PC
1. Launch Pocket DriveExplorer for Pocket PC from the Today Screen
to create a new connection using the Connection Manager
(
Figure 3.1 ).
Figure 3.1 Connection Manager Screen
Using Pocket DriveExplorer for Pocket PC
!
ATTENTION: Risk of injury or death exists from machine motion
when using wireless communications and software to Start/Stop/Jog,
configure or otherwise communicate with a drive.
Using the control bar feature in Pocket DriveExplorer for Pocket PC
(version 2.01 or higher) with wireless communications may present
safety hazards due to potential loss of the wireless connection. For
example, if the wireless connection is interrupted after a start or jog
command is initiated from the control bar, the drive cannot be stopped
using the control bar until the wireless connection is restored. For this
reason, it is required to always use an additional hard-wired stop circuit
to disable the drive.