Step 2: opening the drive – Rockwell Automation 20P PowerFlex DC Drive Analog and Digital I/O Expansion Circuit Board User Manual
Page 3
Advertising
PowerFlex® DC Drive Analog and Digital I/O Expansion Circuit Board
3
Step 2: Opening the Drive
1. Disconnect the DPI cable from the HIM (if present).
2. Remove the bottom front cover from the drive:
a. On frame A drives, remove the screws that secure the bottom front
cover to the drive, then slide the cover down and off the drive chassis.
b. On frame B and C drives, loosen, but do not remove, the screws that
secure the bottom front cover to the drive, then slide the cover down
and off the drive chassis.
=
Disconnect DPI cable
Frame A
Tightening torque:
1.5 N-m (13.3 lb.-in.)
Disconnect DPI cable.
Frames B & C (Frame B shown)
=
Tightening torque:
1.5 N-m (13.3 lb.-in.)
Advertising