B&B Electronics 232MSS2 - Manual (Page 18)

14 Documentation Number 232MSS2-0108 Manual
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445
To Uninstall SSwitch.exe
• From START/ SETTINGS/ CONTROL PANEL
• Select Add/ Remove Programs
• Select SSwitch from the list of programs
• Click on the Add/Remove button
DOS SSTSR
Installation
To Install the SSTSR Program (DOS)
• Insert the Smart Switch software media.
• At the DOS prompt
• Type a:\INSTALL.exe and press the ENTER key.
The following files will be located on your hard drive:
1) SSTSR.EXE - The executable file for the Smart Switch.
2) SETUP.EXE - Configuration program for the SSTSR.
There are two methods to begin the SSTSR program. The first
and preferred way is to use the SETUP.EXE program and the
second is through the SSTSR.COM file.
1) SETUP.EXE Method (preferred)
If the software was installed on your hard drive follow these
steps:
• Type C: and press the ENTER key.
• Type CD\SS and press the ENTER key.
To begin the SSTSR program follow these steps:
• Type SETUP and press the ENTER key. You will be prompted
for parameters (for a description refer to the Parameters
section) that are necessary for the SSTSR to communicate with
the Smart Switch. The value in [ ] are the default values. If this
value is desired, just press the ENTER key.