Step 10, Grill body assembly – Brinkmann 2210 Series User Manual

Page 27

Advertising

Note: When performing Step 10,

Lift grill body from front and
rear panels to avoid injury to
hands and fingers. Be sure
to pass hose/regulator
assembly above cart frame
crossbar.

Step 10

With the help of a friend, place grill
body assembly on preassembled
cart frame. Grill body will rest on
angled top of vertical supports.
Align bolt holes located on the
outside of the grill body assembly.
Secure using four M6 X12mm bolts
with small star washers.

ELECTRONIC IGNITER

FOR ASSISTANCE,

CALL 800-527-0717

FOR OUTDOOR

USE ONLY

BURNER

CENTER

7. To light the left and right

burners, push and turn
control knobs to HIGH.
Follow Step 6.

8. Refer to owner’s manual

for match lighting
procedure.

9. To turn off, turn each

control knob clockwise
until it locks in OFF
position.

NOTE: Turn off LP supply

at cylinder when
appliance is not in use.

GRILL LIGHTING INSTRUCTIONS:

1. Read and follow all warnings

and instructions in owner’s
manual before lighting.

2. Open lid before lighting burner.

3. Make sure all control knobs are
in

the

OFF

position.

NOTE: The CENTER BURNER must

be lit first, then light the left and
right burners.

4. Push and turn the control knob for

the CENTER BURNER to HIGH.

5. Press the electronic igniter and

hold for 3-5 seconds to light burner.

6. If ignition does not occur in

5 seconds, turn control knob

to OFF, wait 5 minutes to allow gas
to dissipate and repeat lighting
procedure.

Grill Body
Assembly