Rockwell Automation 1336T FORCE Language Module Replacement - Manual

1336 FORCEt Language Module
Installation/Replacement
Instructions
This publication will guide you through installation (or
replacement) of the 1336 FORCE Language Module.
!
ATTENTION: This drive contains ESD
(Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required
when installing, testing, servicing or repairing this
assembly. Component damage may result if ESD
control procedures are not followed. If you are not
familiar with static control procedures, reference
A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD
protection handbook.
!
ATTENTION: To avoid a shock hazard, assure
that all power to the drive has been removed before
proceeding with the following procedure. In
addition, verify that the DC bus has discharged by
measuring across the “+DC” and “–DC” terminals
of TB1 with a voltmeter. The voltage should be
0.0VDC.
❏ 1. Remove and lock-out all incoming power to the drive.
Remove the drive cover.
❏ 2. Using the figure below, locate the Language Module for
your drive and note orientation.
Standard Adapter Board
PLC Comm Board
LANGUAGE MODULE
ALLEN --BRADLEY
LANGUAGE MODULE
ALLEN --BRADLEY
ALLEN-BRADLEY
Purpose
Module Replacement