Rockwell Automation 1336S_T_E DRIVE MTG GASKET - Manual (Page 2)

Bulletin 1336 PLUS, 1336 IMPACT, and 1336 FORCE

NEMA Type 4/12 Gasket Kit 1–2
Bulletin 1336–5.87 – November, 1997
You can use the Gasket Kits in the following ranges:
Catalog Number Range Frame Designation
RF2
BRF75
BRF100
CWF10 – CWF50
A4
RF3➀
AQF05 – AQF50
BRF05 – BRF50
A1, A2, A3
RF4
A007 – A015
B007 – B030
C007 – C020
B
RF5
A020 – A030
BX040 – BX060
C025 – C060
C
RF6
A040 – A060
B060 – BX150
C075 – CC125
D
RF7
A075 – A100
B150 – B250
C150 – C250
E
➀ Requires a Series B drive for NEMA Type 4 installations.
Each Gasket Kit contains a NEMA Type 4/12 permanent adhesive
backed gasket.
The self–tapping screws with a thread sealant applied to prevent
water damage have been provided. These screws are sufficient for
mounting the drive in an enclosure with a minimum thickness of 12
gauge––2.67mm (0.1025in).
When properly installed, each Gasket Kit is designed to meet either
NEMA Type 4 (IP65) standards or NEMA Type 12 (IP54) standards.
You must observe the general installation requirements that are
provided in the installation section of your Bulletin 1336 PLUS,
1336 IMPACT, or 1336 FORCE Hardware User Manual.
!
ATTENTION: Electric shock can cause injury or
death. Disconnect all power before working on this
product.
!
ATTENTION: Hazard of injury exists if you are
installing the Gasket Kit on a D or E frame. Refer to
the lifting instructions that were included with this kit.
!
ATTENTION: Drive heatsink surface temperature
may be at or near 100
_C. To avoid burns, do not
contact with the drive heatsink.
Where These Kits Are
Used
What These Kits Contain