Rockwell Automation 1329R Small AC Motors, 1/3-3 HP, User Manual - Manual (Page 4)

4 1329R Small AC Motors
Blower Motor Connection
Vector Duty W180T frame motors may incorporate the use of a
blower motor for cooling. In these cases a single-phase, 115V, 60 Hz
blower motor is used.
Encoder Connection Diagrams
Dynapar H20 – 10 pin M/S Connector
Lakeshore – Epic Connector
The following table is a universal wiring guide for the latching Epic
connector.
Epic Connector or Plain Cable Connections
Starting
The motor should start quickly and run smoothly. If the motor fails to
start, it may be that the load is too great, the applied voltage low or
the motor improperly connected. In any case, immediately shut motor
off, disconnect from power supply, and investigate the cause.
Rotation
Refer to notation on wiring diagram for method of changing rotation.
Ambient Temperature
Each motor nameplate carries a maximum ambient temperature
rating. Motors should not be operated at ambients above this rating.
Pin Signal Color Pin Signal Color
1 Common Black 6 5-15V Red
2 B Green 7 B (NOT) Yellow
3 A Blue 8 A (NOT) Gray
4 Z Violet 9 Z (NOT) Orange
5 No Connection – 10 Shield Braid
!
ATTENTION: Check direction of motor rotation before
coupling motor to load.
Output A
90 ° ± 45 °
360 °
Output B
Index
Electrical
O f
360 ° ± 180 °
Output Terminations
Signal Pin
Output A A
Output B B
Output Z C
Vcc D
Common F
Case G
No Connection E
Output A (NOT) H
Output B (NOT) I
Output Z (NOT) J