Transferring the file to the drive – Rockwell Automation 1336F PLUS II Firmware Download Module Inst. User Manual
Page 6
Advertising
6
1336 PLUS II Firmware Download Module
Transferring the File to the Drive
12.Press the Enter key on your computer once to signal the drive – an
introduction screen will be displayed.
13.Press “F” to enter the Flash Mode. You are now prompted to confirm
your choice “Are you sure?” (y or n).
Important: During the time that the flash memory is being upgraded, the
drive will be in a “non-operational state” and will not have
the ability to control the motor. Be certain that placing the
drive in a non operational state is acceptable.
Press “Y” to place the drive in flash mode (the Power LED on the
module will illuminate). Press “Enter” to continue.
Advertising