Rockwell Automation 1336E IMPACT Control Interface Board L7E, L8E, L9E - Manual

ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other applicable
ESD protection handbook.
To avoid a shock hazard, assure that all power to the drive has
been removed before proceeding with the following procedure. In
addition, verify that the DC bus has discharged by measuring
across the “+ DC” and “– DC” terminals of TB1 with a voltmeter.
The voltage should be 0.0V DC.
Installation Instructions
IN
What These Instructions Contain These instructions contain the necessary information to install a 1336-L7E,
-L8E or -L9E Control Interface Board. For further information on board
wiring and operation, refer to the 1336 IMPACT User Manual —
Publication 1336 IMPACT-5.0.
Allen-Bradley
1336 IMPACT
Control Interface Board
Cat. Nos. 1336-L7E
1336-L8E
1336-L9E
How to Install a 1336 IMPACT
Control Interface Board