Rockwell Automation 1485P KwikLink Lite Connectors User Manual
Page 2
2
4. Mounting the Housing
S
Reconfirm that the cable length matches the cable colors
and then set the cover in the housing and secure it
temporarily.
5. Pressure-Welding the Connector
S
Before pressure-welding expansion connectors, check that
the cable is inserted all the way to the cable stopper and
be sure that it is securely connected.
S
Grip the connector in the center between pliers or a similar
instrument and pressure-weld the connector.
S
When finished, confirm that the connector has been
properly pressure-welded.
Confirm that the locks on the housing are completely
caught on the hooks of the cover.
Be sure you can see the cable in the confirmation
opening.
Drop-Line Connector
Part Names
1485P--K1DL4
Wiring Procedure
1. Cutting the Cable
S
Cut expansion cables perpendicular to the length of the
cable.
S
To prevent short-circuits, cut the cable with a sharp
instrument and be sure there are no whiskers on the
conductors.
2. Connecting the Cable
S
Align the cable labels and cable colors and insert the
cable.
S
The cover is translucent. Confirm that the cable is inserted
all the way.
3. Pressure-Welding the Connector
S
Before pressure-welding expansion connectors, check that
the cable is inserted all the way and be sure that it is
securely connected.
S
Grip the connector in the center between pliers or the
special tool (DWT--A01) and pressure-weld the connector.
S
When finished, confirm that the connector has been
properly pressure-welded.
Confirm that the locks on the housing are completely
caught on the hooks of the cover.
Basic Specifications
Rated current
Power (red/black): 4 A
Signal (white/blue): 0.3 A
Rated voltage
30V DC
Withstand voltage
1000V AC for 1 min.
Suitability for Use
The products contained in this installation sheet are not
safety rated. They are not designed or rated for ensuring
safety of persons and should not be relied upon as a
safety component or protective device for such
purposes. Please refer to separate catalogs for
safety-related products.
Rockwell Automation shall not be responsible for conformity
with any standards, codes, or regulations that apply to the
combination of the products in the customer’s application or
use of the product.