Rockwell Automation 1757-FIMRTP ProcessLogix Remote Termination Panel (RTP) Installation Instructions - Manual (Page 4)

4 ProcessLogix Remote Termination Panel (RTP)
Publication 1757-IN915A-EN-P - October 2001
Installing the 1757-FIMRTP
Mount the RTP onto a DIN Rail
Use the enclosed instruction sheet to attach the brackets and mount the RTP onto a
DIN rail.
Mount the RTP with Optional Enclosure onto a DIN Rail
Follow these steps to attach the brackets and enclosure, then mount the RTP onto a
DIN rail:
1. Replace the screws on the RTP with the longer screws shipped with the
enclosure.
2. Seat the RTP into the enclosure by placing the screws through the pre-drilled
holes in each corner of the enclosure.
3. Use the instruction sheet to attach the brackets and mount the RTP and
enclosure onto the DIN rail.