Installation – Bogen NEAR ORBIT OPS1 User Manual
Page 4
Installation
If the power level is known, then select it using the front-mounted selector switch
prior to installing the OPS1. See section Selecting Power Levels.
SUSPENSION CABLE ASSEMBLY
1
. Screw nuts onto the eye bolts all the way to
the flange.
2. Screw in eye bolts with captured cable sec-
tions in to the three suspension points.
Do not overtighten.
3. Snap loops of free end of cable sections into
quick-snap clip.
4. Connect quick-snap clip to anchor point or
drop cable. Bogen’s CK10 cable kit is suit-
able for use as the drop cable.
SAFETY CABLE
The OPS1 includes a safety cable suspension point for extra protection.
The thread of the suspension point is a 1/4-20" x 1/2" thread. Bogen offers a cable
kit as an optional accessory (CK10) that is suitable for use as the safety cable.
2
IMPORTANT
The anchor point, drop cable, and hardware used to hang the speaker must be able
to support the speaker’s weight under all conditions. IF YOU ARE NOT SURE OF
THE PROPER CAPACITY OF THESE ITEMS TO USE, CONSULT A STRUCTURAL
ENGINEER. Mount only one speaker per supplied quick-snap clip.
1.
2.
3.
4.