Rockwell Automation 1746-XXXX SLC Removable Terminal Blocks Instruction Sheet - Manual (Page 2)

Publication 1746-5.9 - June 1999 PN 40071-010-01(B)
Supersedes 1746-5.9 - February 1995 © 2007 Rockwell Automation, Inc. All rights reserved. Printed in Singapore.
Installing the Removable Terminal Block
1. Be sure the color of the RTB matches the color band on the module.
2. Write the appropriate slot, chassis, and module type on the RTB label.
3. Remove power from the SLC 500 system.
4. Align the terminal block release screws with the mating connector in the
module.
5. Press the RTB firmly onto the connector contacts.
6. Tighten the terminal block release screws. To avoid cracking the terminal
block, alternate the tightening of the screws.
ATTENTION: Inserting a wired RTB on an incorrect module
can damage the module circuitry when power is applied
ATTENTION: Never install or remove RTBs or modules while
the SLC 500 system is powered.
Terminal Block Release Screws
Maximum Torque = 0.7-0.9
Newton-Meters (6-8 in./lb.)