Rockwell Automation 1746-SIM SLC 500 Input Simulator Installation Instructions - Manual (Page 2)

2 SLC 500 Input Simulator
Publication 1746-IN024A-EN-P - October 2001
Installing the Input Simulator
1. Remove the RTB from the input module. To avoid cracking the RTB,
alternate between the two release screws when loosening.
ATTENTION
!
Installing the 1746-SIM on a module other than those listed
above can damage the module and expose you to hazardous
voltages.
ATTENTION
!
Never install or remove RTBs (removable terminal blocks) or
modules while power is applied to the SLC system.
Terminal Block Release Screws
Maximum Torque = 0.7 to 0.9 Nm (6 to 8 in-lb)
1746IN024AENP.fm Page 2 Tuesday, December 4, 2001 11:26 AM