Blue Rhino 200209 - Manual (Page 11)

10 Owner’s manual and assembly instructions: model 200209 outdoor patio heater 1/15/03
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 9 – Attach Dome to Emitter
• Line up holes in dome assembly with the studs from the emitter
assembly and lay dome assembly in place. Secure with three nuts.
• Place dome cap over center bolt, making sure that the three slots in
cap lay over each Rib
• Thread on finial until tight.
Step 10 – Secure Gas Line
• Make sure angled side of Gas Clip pokes up through large hole in
Platform.
• Tighten screw until Gas Line is held securely in place.
• Stand Heater upright.
Step 11 – Connect Gas Line to Cylinder
The pressure regulator and hose assembly supplied with the appliance
must be used and replacements must be those specified by the
manufacturer.
Caution: Before you attempt to use a propane cylinder,
understand all cylinder and propane related precautions in
Section #1 - “Safety First.”
• Slide full Propane Cylinder onto Heater Base.
• Attach Gas Line to Cylinder by turning black plastic knob clockwise
over Cylinder valve until tight.
Note: Be careful not to kink flexible hose of Gas Line.
• Secure cylinder in place by attaching loose end of Cylinder Restraint
Chain to hole in left leg.