Bakers Pride FC-616 - Manual (Page 3)

3
Sketch “A”
3/4 NPT
Gas Inlets
Lintel Plate
Louvered Service Panel
115VAC, 15 Amp
NEMA 5-15P
60°
16” (406mm)
Left Side View
I. INSTALLATION INSTRUCTIONS
1. RECEIVING:
Read the notice on the outside carton regarding damage in transit. Damage discovered after
opening the crate(s) / carton(s) is “CONCEALED DAMAGE” and the carrier must be notified
immediately to send an inspector and also furnish the forms for the consignee's claim against the
carrier.
When oven arrives, it should consist of : A crate, or carton, containing your new oven, a carton,
containing 4 legs with mounting hardware, and a strapped skid, containing baking decks.
Installation must conform with local codes and/or with the latest edition of the ANS Z-233.1 National
Fuel/Gas Code in USA / CAN/CGA-B 149.1 or 2 Installation Code in Canada.
This appliance must be installed by a competent person. In the U.K., Corgi registered Installers
(including the regions of British Gas) undertake to work to safe and satisfactory standards. This
appliance must be installed in accordance with the current Gas Safety (Installation and Use)
Regulations and the relevant Building Regulations / IEE Regulations. Detailed
recommendations are contained in the British Standard Codes Of Practice BS 6172, BS 5440:Part
2 and BS 6891.
Place the oven and parts as close as possible to the area of final installation before un-crating.
2. CLEARANCES:
Minimum Clearance From Combustible Construction Non-Combustible Construction
Left Side 3” (76 mm) 0
Right Side 1” (25 mm) 0
Rear 3(76mm) 2” (51 mm)
Front and Flue Area - Enclose only with non-combustible materials.
In MASSACHUSETTS: All gas products must be installed by a “Massachusetts” licensed plumber
or gas fitter. Ventilation hoods must be installed in accordance with NFPA-96, current edition, with
interlocks as described in that standard.