Bakers Pride FC-616 - Manual (Page 5)

5
Sketch “D” Sketch “D”
BA ER P ID K S R E
V
d (No
I
ent H
oo
t nclu
ded)
A. MOUNTING LEGS WITH CASTERS:
Legs are shipped in a separate carton complete with mounting hardware and casters, (two of them
with wheel brakes).
NOTE : Installation should be made with a connector that complies with the latest edition of the
Standard for Connectors for Movable Gas Appliances ANSI Z21.69 in the USA (CAN CGA6.16 in
Canada) and a quick disconnect device that complies with the latest edition of the Standard for
Quick Disconnect Devices for use with gas fuel ANSI Z21.41 in the USA (CAN CGA 1-6.9 in
Canada) and adequate means must be provided to limit the movement of the appliance without
depending on the connector and any quick disconnect device or its associated piping. The restraint
should be attached to the rear legs of the oven on which casters are mounted. If disconnection of
the restraint is necessary to move the oven for servicing needs, the restraint should be reconnected
after the appliance has been returned to its originally installed position.
a) Bolt two (2) legs with casters and wheel brakes firmly to the two (2) upper (front) corners of
the oven as it stands on the skid (see Sketch “E”).
b) Using proper lifting equipment, lower the oven down so that the two bolted legs rest on the
floor (see Sketch “F”).
c) Using proper lifting equipment, raise the back side of the oven to a height slightly higher
than the height of the legs, remove the skid and place a sturdy support under the back side
(see Sketch “G”). Mount remaining two (2) legs and tighten bolts. Lift the oven and remove
the supports.
d) Move the oven to its final location, keeping the minimum clearances from the back of the
oven to the wall. This clearance is necessary for safe operation and to provide proper air
flow to the burner chamber.