Bakers Pride FC-616 - Manual (Page 7)

7
Sketch “I”
Fou
r De
ck
Wedges
C. Optional Ceramic Top Installation (Refer to “Top Brick Lining”, Page 8):
If the oven was ordered with the ceramic top option, the two top supports are already installed.
Simply slide in the ceramic tops as per instructions below. If this option is an add-on, you must follow
the instructions provided with the Ceramic Top Installation kit.
a) Through the arched front opening, insert one of the center slabs (20 13/16 x 20 13/16 for FC616
and FC816)(17 1/2 x 17 3/4 (left to right) for the FC516) into the bake chamber, raise one side
until the other side comes to rest onto the center support, then lower the first side to lock it in
between the two center supports. Push it to the rear as far as possible to make room for the
second center slab.
b) Install the second center slab (20 13/16 x 20 13/16 for FC816)(14 3/16 x 20 13/16 (left to right)
for FC616)(17 1/2 x 17 3/4 (left to right) for FC516) into the bake chamber and push it tightly
against the first slab.
c) Install the side slabs (20 13/16 x 20 13/16 for FC816)(17 1/2 x 17 3/4 (left to right) for FC616)(17
1/2 x 13 3/4 (left to right) for FC516) in a similar fashion, raising the slab in the center until the
lower side edge rests on the side support, then lowering the upper edge onto the center support.
First the ones in the rear, then the ones in the front, pushing them tightly against the first slabs.
5. BOOSTER BURNER INSTALLATION:
NOTE: The Booster Burner and the Booster Burner Guard are shipped inside the burner
compartment and have to be installed before the booster burner can be used for the first
time.
a) Once the Pizza Deck Slabs are installed as per instructions above, place the booster burner and
guard inside the bake chamber, as far back as possible, then follow with your upper torso and do
the following:
b) Center the guard in front of the booster burner brackets, flange down, wings back, then push it
all the way back and under the booster burner brackets.
c) Reach over the guard, slip the throat of the booster burner over the gas nozzle, then lower it and
insert the two burner ends into the locating slots of the booster burner brackets and push them
all the way down.
6. GAS AND ELECTRIC CONNECTIONS:
NOTE: Propane Gas Units are not available in the European Community.
a) Normal factory connections are made for 120 Volts AC, 60 Hz operation in USA and Canada.
For use in Europe, the connections are made for 230 Volts AC, 50 Hz operation.
b) The appliance, when installed, must be electrically grounded in accordance with local codes
and/or the latest edition of the National Electric Code ANSL/NFPA 70 in USA (Canadian Electric
Code CSA C22.2 in Canada).
Front View
Left Deck
Wedge
Left Interior Oven Wall