Rockwell Automation 2711-NMCC, -NMCD, -NMCE Memory Card Retainer for PanelView Terminals - Manual (Page 2)

2 Memory Card Retainer for PanelView Terminals (2711-NMCC, -NMCD)
Memory Card Retainer
for PanelView Terminals
(2711-NMCC, -NMCD) The memory card retainer is required for UL508 installations with a
memory card installed. The retainer protects against Electrostatic Discharge
(ESD) up to 15KV and prevents accidental removal of a memory card in
high vibration environments.
•
Use Catalog No. 2711-NMCD for PanelView 550 touch-only terminals.
•
Use Catalog No. 2711-NMCC for PanelView 550 (except touch-only), PV600,
PV900, PV1000 terminals.
•
Use Catalog No. 2711-NMCE for PanelView 300 keypad and PV600
touch-only terminals
To attach the memory card retainer:
1. Secure the base of the retainer over the existing memory card slot using
the two screws provided. Tighten the screws to a torque of 6 to 8
inch-lbs. (.7 to .9 N
· m).
2. Insert the memory card and install the retainer.
3. To remove the retainer, press the tabs on each side and pull.
Retainer Base
Memory Card
Retainer
Base
Mounting Screws
PanelView 600 shown, others are similar