Install the modules into the baseplate, Specifications, N2 module specifications – Rockwell Automation 1798-N2 FlexArmor Module User Manual
Page 3
FlexArmor Module 3
Publication 1798-IN008A-EN-P - January 2001
Install the Modules into the Baseplate
To install the modules into the Baseplate:
1. Hold the N2 module at an angle and engage the top of the
module in the indention on the rear of the Baseplate.
2. Press the module down flush with the panel until the locking
lever locks.
3. Screw down the module retaining screws to ensure IP67
compliance.
Specifications
N2 Module Specifications
IMPORTANT
Torque the screws to 0.5-0.7 Nm. (4.43 - 6.2 inch
pounds).
Specifications
1798-N2
Module Type
Dummy
Dimensions (H x D x W)
118 mm X 50 mm X 40 mm
4.63 in. X 1.95 in. X 1.58 in.
Enclosure
Meets IP67
Agency Certification
(When product is marked)
CUL listed
CE marked for all applicable directives
marked for all applicable acts
N223