Rockwell Automation 6155F-NPXPDC Compact Non-display Computers - Manual (Page 10)

10 Compact Industrial Non-display Computers
Rockwell Automation Publication 6155R-IN002E-EN-P - July 2013
3. Attach and secure the DIN rail to the installation surface (3).
4. Mount the computer on a DIN rail.
a. Insert the upper lip of the DIN-rail bracket into the top edge of the DIN rail.
a. Press the computer firmly against the lower edge of the DIN rail
(4).
5. Secure the installation by tightening the fastener on the DIN-rail bracket and torque to
1.18 N•m (10.42 lb•in)
(5).
VESA Mount the Computer
You can mount the computer to any Allen-Bradley industrial monitor or other surface by using
the provided VESA mounting bracket. This bracket is compliant with the VESA 100 x 100 mm
mounting hole pattern. See page
11 for the VESA mounting bracket dimensions.
1. Attach the VESA mounting bracket to the installation surface (1).
2. Secure the VESA mounting bracket with the four M4 x 8 mm flathead screws (2).
3. Place the computer on the VESA mounting bracket (3).
4. Secure the installation with four M4 x 8 mm screws (4).
Torque the screws to 0.686 N•m (6.072 lb•in).
TIP If you are using an existing DIN rail, skip step 3.
IMPORTANT If you are VESA mounting to the back of the monitor, the computer I/O panel must be facing
down, and the monitor must be mounted vertically and not at an angle.