Bunn FMD-2 - Manual

4. Twist the Whipper
Chamber clockwise and
pull it off the Whipper
Chamber Receptacle.
5. Pull the Frother off
the Motor Shaft. Notice
the flat keyway on the
shaft and the matching
keyway inside the Frother.
It is important that these
two keyways are lined up
when reassembling.
6. Twist Whipper Cham-
ber Receptacle clockwise
and pull it off the Motor
Shaft.
8. Wash components in
a mild solution of dish
detergent using a bristle
brush. Rinse and dry each
item thoroughly before
reassembling.
CLEANING INSTRUCTIONS for FMD-2 & 3 POWDER MIX DISPENSERS
NOTICE - This guide is for quick reference only and is not intended to replace the information in the Operation Manual!
RECOMMENDED DAILY CLEANING
1. Open the Cabinet
Door.
3. Pull the Mixing Cham-
ber out of the Whipper
Chamber.
7. Slip the O-ring off the
Whipper Chamber Re-
ceptacle and remove the
shaft seal.
35112.0000B 11/04 ©2002 Bunn-O-Matic Corporation
2. Remove the steam
collector by pulling it for-
ward and twisting in a
clockwise rotation.
DISASSEMBLY & CLEANING THE WHIPPER CHAMBERS (Once a week)
1. Empty the Drip Tray
and wash components
in a mild solution of dish
detergent using a bristle
brush. Rinse and dry each
item thoroughly before
reassembling.
3. Remove Hoppers and
refill with product.
2. Rinse out the Whipper
Chambers by placing the
RINSE/RUN switch in
the RINSE position and
activating the DISPENSE
switch for 5 to 10 second
bursts.