AJA Ki Pro - Manual (Page 75)

Ki Pro v3.2 www.aja.com 75
Figure 22. Ki Pro Web Interface, Config Screen
NOTE: In the following web screen control definitions, the number in parentheses refers to the
Parameter descriptions in Chapter 2—you can read more information there about the
choices and their meanings.
Record Type (1.1): This parameter defines the frame recording method of media stored. RECORD TYPE can
be configured to record the incoming video signal in a “NORMAL” manner, as a “PsF”
signal if the incoming source is 1080psf 29.97 (for example), or VFR for variable framerate
recording of the SD-SDI/HD-SDI input (such as Varicam).
1080p Playback (1.3): This parameter defines the format applied when 1080p media is played bac k off from
storage. You can choose Playback as standard 1080p progressive frame or 1080
progessive segmented frame (regardless of what was recorded when input).
In Convert (1.4): This parameter defines the type of up, down, cross, or aspect-ratio conversion, if any,
applied to the selected input when recording. Selections are None, SD, HD 720, or HD
1080.
Out Convert (1.5): This parameter defines the type of up, down, cross, or aspect-ratio conversion, if any,
applied to the output. Selections are None, SD, HD 720, or HD 1080.
SDI Output (1.6): This parameter defines whether the SDI output matches the file format or has the 1.5
OUT CONVERT selection applied to it.
Component Output (1.7): This parameter defines whether the component video output matches the file format or
has the 1.5 OUT CONVERT selection applied to it.
HDMI Output (1.8): This parameter defines whether the HDMI output matches the file format or has the 1.5
OUT CONVERT selection applied to it.
Super Out (1.9): This parameter enables or disables superimposition of timecode and transport state
(Record, Pause, etc.) onto the SDI, SDI2, Component, HDMI, and CVBS on Y outputs.