AJA Ki Pro Rack - Manual (Page 79)

Ki Pro Rack v4.2 www.aja.com 79
Figure 21. Ki Pro Rack Web Interface, Transport Screen—Show Gang Control
Parameters for each available Ki Pro will appear in the Gang Controls area. These include:
System, Input Format, Free Storage, Gang, Master and Settings. Ki Pro units that may be
added to a gang will appear under the System column. The Input Format column gives
information on what type of video format/framerate each system is receiving. Free
Storage allows for an "at a glance" view of the capacity of the media in each unit. Gang is
where the units can be added or removed from the gang. Master allows the promotion
of a Ki Pro unit to the "controlling" role in the gang. Settings allows for the configuration
of clip names on the Master and Slave Ki Pro units.
To add a Ki Pro to a gang, simply select the checkbox for the unit in the Gang column. As
a shortcut, if all available Ki Pro units are desired for a gang, select the "All" item below
Gang. Alternately, if you want to clear units from a gang, deselect them or use the "Clear"
option.
IMPORTANT: There can be only one Master in a gang; typically, the IP address for the Ki Pro unit you entered
and are viewing the web UI on is the one which should be promoted to the "controlling" role. If
the unit with the IP address that is currently being viewed via the web UI is selected, a red
capitalized "MASTER" text will appear on the webpage above the columns.
A Master Ki Pro unit can send three items to the slave Ki Pro units within a gang; a record start
command, a stop command and clip naming. The record start and stop commands are
controlled from the web UI Transport area above the gang information on the Master Ki Pro
unit or via physical front panel buttons (provided the unit is set to "Local Only" for the CONFIG
parameter 35.2).
The Settings area is where the Ki Pro clip name for each unit is decided. By default, the Ki
Pro Rack is configured to use the standard clip naming conventions, not the custom clip
naming conventions. The first user selection is "Use Custom Clip Name"; if the user wants
to use the standard clip naming convention, leave this set to "OFF", but if the user wants
to create a custom clip name, mouse click on the "OFF" to reveal a pulldown for "OFF/ON"
selection, then click "OK".
If "OFF" was selected, the next parameter would be "Clip Name", again, clicking on the
"SC" or "Clip" presented brings up the pulldown and the "OK" box. "Clip Number" must
be entered manually with a valid value for Ki Pro Rack of 1 through 999 and then the
enter/return key must be hit. NOTE: If the enter/return key is not entered after the