AJA LUT-box - Manual (Page 17)

LUT-box Mini-Converter v2.1r1 www.aja.com 17
Audio Tab Screen
Figure 16. MiniConfig, Audio Tab Screen
Audio Selections Use the Audio screen to view and make changes to the LUT-box settings.
NOTE: When using the DVI video protocol no audio is output on the HDMI connector, since that
protocol is video only.
Input Source: Choose which group of eight embedded SDI input audio channels on the SDI1 input
connector to use for routing to the audio outputs.
• SDI1 Ch. 1-8
• SDI1 Ch. 9-16
Output Channel Count: Choose Auto, 2-channel or 8-channel embedded audio for the HDMI output. Choosing
“Auto” automatically selects the audio channels based on the attached device's
capabilities. This control does not affect the SDI output, which always embeds 8 audio
channels.
Analog Audio Select: Choose which two incoming SDI audio channels from the selected group are routed to
the analog audio outputs. Choose from Ch 1-2 (9-10) through Ch 7-8 (15-16).
Audio Offset In Frames: Permits time shifting the audio outputs in relationship to the video (for example, to
correct for lip sync problems), in 1/16 of a frame increments. Delay range is up to +7.0
video frames. The actual time duration of delay will vary depending on the frame rate of
the format being converted.
NOTE: Any video to audio delay caused by LUT processing is automatically corrected. Zero offset sets
the output video to audio relationship the same as the incoming signals.