Dip switch settings summary, Installation – AJA HD10A-Plus User Manual
Page 7
HD10A-Plus v1.0r1
www.aja.com
7
DIP Switch Settings
Summary
Analog video input formats and the DIP switch settings for them are shown in
Installation
Typically, HD10A-Plus installation consists of the following:
1. Configure the DIP switch for the desired equipment configuration and video formats.
Power to the converter may be on or off when this is done (the converter will respond
to DIP switch changes at the time they are made, so power cycling is not necessary)
2. Ensure video equipment is properly connected to the converter. Check all converter
BNC connections.
3. Ensure the converter has a proper power supply source: +5 to +20VDC power. The
AJA power supply model DWP is included.
Table 2. Analog Input Format DIP Switch Settings
DIP Switch Settings
Input Std
Input Analog Format
1
SD Video
2
S-Video
3
Pedestal
4
Format
5
NTSC-J
525i59.94
Composite NTSC
Right
Left
X
X
Left
525i59.94
NTSC S-Video
Right
Right
X
X
Left
525i59.94
Composite NTSC-J
Right
Left
X
X
Right
525i59.94
NTSC-J S-Video
Right
Right
X
X
Right
525i59.94
Component YPbPr SMPTE/EBU-N10
Left
X
Right
Left
Left
525i59.94
Component YPbPr Betacam
Left
X
Left
Left
Left
525i59.94
Component YPbPr Betacam-J
Left
X
X
Left
Right
625i50
Composite PAL + S-Video
Right
Left
X
X
X
625i50
PAL S-Video
Right
Right
X
X
X
625i50
Component YPbPr SMPTE/EBU-N10
Left
X
X
Left
X
720p *
Component YPbPr SMPTE/EBU-N10
X
X
X
Left
X
720p *
Component RGB
X
X
X
Right
X
1080i/psf *
Component YPbPr SMPTE/EBU-N10
X
X
X
Left
X
1080i/psf *
Component RGB
X
X
X
Right
X
* = all supported frame rates
Note: X = don't care