AJA UDC - Manual (Page 21)

UDC Mini-Converter v2.3r1 www.aja.com 21
Software Update
Procedure
Use the Update screen to update the UDC software as follows:
1. Check the AJA website for new Mini-Config software for your Mini-Converter. If you
find new software, download it and uncompress the (zip) file archive. Use this URL to
check for new software:
http://www.aja.com/en/products/mini-converters/mini-config-software#support
2. Connect the Mini-Converter to a Mac or PC via a USB port on the computer, and run
the new Mini-Config software you just downloaded.
3. Click on the Update tab screen.
4. Check the Installed version level against the Desired version level. If the Desired is
newer, click the Update button to download the new firmware to the Mini-Converter;
progress will be shown via the “Progress” thermometer bar.
Info Tab Screen
This screen provides basic information about the Mini-Converter. This information, which
consists of unit identifying information, is mostly useful when calling AJA Support for
service or technical support.
Figure 15. Mini Config, Info Screen
Name: This field allows you to give your Mini-Converter a name. This may be useful if you
have several Mini-Converters attached to a single Mac/PC via USB so you can distinguish
one of them easily (especially if they’re the same model). In the example show previously,
the UDC has been named “pilot.” To change the value, type in a new name and click the
“Set Name” button.
Type: This is the factory set model name of the Mini-Converter (UDC).
Assembly: This is the factory assembly number.
Serial Number: This is the factory set unique serial number of your UDC. If you ever call
AJA Support for service, you may be asked for this number.