AJA RH10UC - Manual (Page 4)

4
I/O Connections
FR1 and FR2 BNC Connector Assignments, RH10UC Card Module
When the RH10UC module is installed in an AJA FR1 or FR2 frame, a corresponding group
of 9 BNCs on the rear panel then provide I/O for the module. The illustration above shows
the connector assignments for both the FR1 and FR2 when used with the RH10UC.
Installation
Typically, RH10UC installation consists of the following:
1. disconnect power from the frame (remove line cord)
2. remove the FR1/FR2 front panel
3. install RH10UC card module
4. replace the FR1/FR2 front panel
5. apply power to the frame by connecting a north american-style power cord from
the frame to mains power (90 to 260 VAC)
!
Warning!
Ensure Mains Power is disconnected before installing the FR1 or FR2 frame R-series
modules into the frame, or installing and removing options. If a Mains switch is not
provided, the power cord(s) of this equipment provide the means of disconnection.
The socket outlet must be installed near the equipment and must be easily accessible.
Warning!
FR2 Dual Power Cord Notice—please read this. To reduce the risk of electrical shock,
disconnect both power cords before servicing equipment.
Caution!
The FR1/FR2 front fan door is heavy and is not hinged. Remove with Caution.
Instructions for removing the frame front door for module installation is discussed in the
FR1/FR2 User Manual.