AJA R44E - Manual (Page 4)

4
I/O Connections
FR1 and FR2 BNC Connector Assignments, R44E Card Module
When the R44E module is installed in an AJA FR1 or FR2 frame, a corresponding
group of 9 BNCs on the rear panel then provide I/O for the module. The
illustration above shows the connector assignments for both the FR1 and FR2
when used with the R44E.
User Controls
The user interface for the R44E includes four 4-
position dipswitches and four status LEDs. Each
LED illuminates when an SDI input signal is
detected at its respective channel. The dipswitches
are used to configure output format, blanking,
pedestal and select color bars for testing. The
following table under “
Control Functions” shows
what each of the four dipswitch positions perform.
All dipswitches function identically for their
respective channels. The channel number is
marked on the front of the circuit card next to each
dipswitch and LED.
SDI SDI SDI SDI
SDI
SDI
SDI
SDI
DIP switches
LEDs