Ambient Lockit Slate, ACN-LS - Manual (Page 25)

experience quality. ACN-LS
www.ambient.de/en
23
ACN > TX / RX
TX is a wireless transmission of external time code
present on the input (Lemo socket pin2). This is
intended for transmitting a record-run time code to
another ACN-LS, ACN-TL or ACL 204 which is in RX
mode. Once progressing time code is detected, the
ACN-LS jams to it and sends a jam command to the
slaves.
When external time code stops, either in form of a
static time code or if the signal is off for two seconds,
a stop command is sent to the slaves.
If static time code value is recognized, as put out by a
video camera or Sound Devices recorder, the time
code is stopped and a static time code is put out on the time code output of the slaves as well
as on the output of the unit that is in TX.
This feature makes it possible to remotely start and stop recording of audio recorders,
cameras and video recorders which support being triggered by time code.
In RX mode, the slate is a time code receiver and displays time code sent from another ACN
device in TX mode
As in JAM mode, the network channel needs to be set first when coming from OFF condition
but can be changed any time. Other available settings are activating LNA and setting the
output power of the wireless module. PIN is required for higher output levels.
EXIT
Exits to the main operation screen.